SONGPU RECARE MEDICAL PRODUCTS LIMITED
Overall Length: Minimum 180mm (without teat)
Width when Flat Laid: 19±2mm,53±2mm,57±2mm
Wall Thickness:0.03~0.09mm
Elongation at Break:Minimum 650%
Tensile Strength:Minimum 17Mpa
Bursting Volume: Minimum 1Kpa
Inspection: 100% Electronically Tested
Color: Nature White~~and any other color
The journey of a condom usually starts in Southeast Asia, and begins with the collection of latex, asubstance found in several plants, but particularly, not surprisingly in the rubber tree.The white liquid is “tapped” from the rubber tree, and its quality carefully evaluated. Our condom manufacturing plant is very professional, from latex trees to customers, it requires11 magic steps:
1. A strictly secret latex mix, the basis of the condom production, is prepared.Best raw latex,stabilizers and fine dispersedvulcanization chemicals are homogenized.
2. The mix matures were kept for a certain time in curing containers and reaches the required quality levels.
3. At the right degree the latex compound is fed into dip tanks of the production lline.
4. Glass formers (in the shape of the condom you want to make) are fastened to an endless chain, run one after anotherthrough the dipping tank and receive a thin latex film.Dip thrice into dip tanks.The speed of the chain and the viscosity of the latex compound define the required thickness otthe condom.
5. Rotating brushes from a bead at the open end of the dryinng semi-processed condoms.
6. The condoms go through a vulcanisation zone.
7. The condoms go into a hot soapy water bath, which enables the condoms to be wiped from the glass formers and alsoremove any chemicals that may stll be on the latex. t also washes the glass clean to start the process from Step 4.
8. The still wet condoms are taken to "condom washing machines where the condoms are "washed" with skin friendlypowder, which again removes any residue of chemical that may be left from the previous process.
9. Every single condom must then be electronically tested, by putting them on a metal phalic shaped model, and allowing ametal brush to run around the outside of the condom. If a hole is present an eletrical circuit is made and condom is reiectedautomatically.
The above are the steps of our condom manufacturing company to produce condoms.
Recare brand started 1997 aiming to develop a condom brand and medical products brand of the highestquality,lower price - Recare brand will help to make a world that human being can care each other.
RECARE BRAND ADVANTAGES:
